PRODUCTION OF WOOD ENERGY BY CHIPPING

1. Dane Marčeta, Faculty of Forestry, University of Banja Luka, Republic of Srpska, Bosnia and Herzegovina
2. Vladimir Petković, Faculty of Forestry, University of Banja Luka, Republic of Srpska, Bosnia and Herzegovina
3. Gordana Lakić Globočki, University of Banja Luka, Faculty of mechanical engineering, Republic of Srpska, Bosnia and Herzegovina

Increasing demand for using renewable energy resources is strongly emphasized during the last decades. On the international level, it is recognized through a series of conventions, conclusions and recommendations. Forests are energy source through conversion of wood biomass into solid, fluent and gaseous fuels for industrial and domestic use. Wood chip is a form of biomass, size of 5-50 mm, which is obtained by chipping of lower quality logs, trees, brushwood and wood residues. Some investigation showed that choosing the right chipper is crucial in a projection of chipping system. In this study, it was compared chipping at the landing site with the Jenz HEM 700 and Pezzolato PTH 1300/1500 chippers. The subject of chipping was beech long fuelwood and stacked fuelwood. The investigation was done with the time and work-study method. Cost calculation was performed according to FAO methodology, slightly modified for local conditions. Also, in simulations, Jenz HEM 561 DQ was included in order to cover a wider range of chippers by the capacity, but data for this chipper were undertaken from other research. Unit costs of chipping were calculated on the basis of raw material input and chipper output. Unit costs were expressed for factory projected chippers productivity also, in order to compare obtained unit costs with costs when chippers are working below full capacity. Results of the productivity and cost calculation of chippers showed that bigger chippers had lower unit costs, but because of inability to achieve full capacity at the forest landing site and because of their dimensions which hinder the manipulation, it can be recommended using of chippers of smaller capacity like Jenz HEM 561 DQ or even smaller.

Ključne reči: wood energy; chipping; productivity; cost

Tematska oblast: SIMPOZIJUM A - Nauka materije, kondenzovane materije i fizika čvrstog stanja

Datum: 18.07.2019.

Contemporary Materials 2019 - Savremeni Materijali


Ostali radovi sa konferencije


Pretraži radove