https://www.high-endrolex.com/10

eKonferencije.com: Simulation casting point in the process of plastic injection under pressure

Simulation casting point in the process of plastic injection under pressure

1. Amir Ćoralić, Bekto Preciza, Federation of Bosnia and Herzegovina , Bosnia and Herzegovina
2. Mersida Manjgo, Federation of Bosnia and Herzegovina , Bosnia and Herzegovina
3. Anel Maslo, Bekto Preciza, Federation of Bosnia and Herzegovina , Bosnia and Herzegovina
4. Senad Rahimić, University Dzemal Bijedic - Mostar, Federation of Bosnia and Herzegovina , Bosnia and Herzegovina

The most common problems, which with the manufacturers of tools meet in their work are: defects in the casting part that reveals only in the production process, so it is losing a lot of money and time on corrections, while sometimes the only solution is to design and production of tools again.
In this paper it will be shown, using CAE system, which are mainly based on the finite element method analysis of injection casting technology, which refers to the simulation of tool cavity filling, cooling process and contraction allowing for removal of shortcomings, such as the accumulation of materials, parts with thin walls, the problems in the flow of material, the residual gases, etc., which significantly reduces waste

Ključne reči :

Tematska oblast: Production and Computer-Aided Technologies

Datum: 02.02.2017.

13th International Conference on Accomplishments in Mechanical and Industrial Engineering

Datoteka uz rad  (4.01 MB)


Ostali radovi sa konferencije


Pretraži radove

https://www.high-endrolex.com/10