1. Dragan Adamović, Faculty of Engineering, University of Kragujevac, Sestre Janjić 6, 34000 Kragujevac, Srbija 2IMW Ins, Serbia
2. Milentije Stefanović, Faculty of Engineering, University of Kragujevac, Sestre Janjić 6, 34000 Kragujevac, Srbija 2IMW Ins, Serbia
3. Miroslav Plancak, Faculty of Technical Sciences, Department for Production Engineering, Serbia
4. Srbislav Aleksandrovic, Факултет инжењерских наука Универзитета у Крагујевцу, Serbia
The paper gives definitions and explanations about forming limits for the area of bulk forming and sheet metal forming. The significance of stress state and strain history for limit strains realization is emphasized above all. For the case of upsetting, indicators in the system of principle surface strains are specified, as well as classic example of FLD, as a dependence of limit strain on stress ratio coefficient. For the case of sheet metal forming – deep drawing, the example of determining FLD at classic and two-phase - proportional forming – is shown. The specified experimental results are related to the area of biaxial tension-stretching and the area of pure deep drawing of axis-symmetrical pieces.
Тематска област:
Уводни рад:
Да
Датум:
03.03.2011.
Бр. отварања:
839
11th International Conference on Accomplishments in Mechanical and Industrial Engineering
Датотека уз рад
(2.91 MB)
